CNC lathe equipment operating procedures

1. The operator must be familiar with the structure and performance of the CNC lathe. After passing the professional training before taking up the post, the operator can take up the post with a certificate after passing the examination. It is strictly forbidden to use the equipment under overload.

2. Be familiar with and correctly compile the operating procedures to prevent overtravel.

3. Protect the CRT device; do not allow any material other than your hands to touch the touch switch of the operating keyboard.

4. Correctly adjust and protect each limit device and keep it in good working order.

5. Use and replace the battery of the memory correctly on schedule to prevent data loss.

6. Moisture and dust prevention should be done well, and do not let it enter the electric furnace system to maintain stable operation.

7. Use and protect the encoder correctly as required to make it work stably for a long time.

8. If the machine tool does not run for a long time, the control switch should be turned off to protect the power amplifier part.

9. The machine should be driven for 3-5 minutes before work, and normal operation can be performed only after confirming that the lubrication system is unobstructed.

10. It is strictly forbidden for the operator to leave the machine tool that is running.

11. When processing heavy workpieces, a balancing device should be added and the speed should be appropriate.

12. It is not allowed to place tools and metal materials on the machine tool rails and headstock.

13. When processing slender workpieces, it is not allowed to extend too long at the rear end of the machine tool. If necessary, a material rack should be installed.

14. If the machine tool is found to be working abnormally during work, it should be stopped immediately and the machine should be started again after troubleshooting.

15. After the work is over, the machine tool should be maintained, cleaned, lubricated, and the power supply should be cut off.

16. During the operation of the machine tool, it is strictly forbidden to use various substances to contact the rotating workpiece and chuck.