Some processing instructions and detailed analysis of vertical lathe failures

CNC vertical lathe, seeing these four words, everyone should be familiar with them, because we have been studying this important product of the website, and so far, it has not been completed, because it contains too much knowledge. So, next, we might as well strike while the iron is hot and continue, so that we can increase our knowledge in this area and make progress in our learning.

1. Which lathe is suitable for processing smaller workpieces?

This question is not difficult to answer for vertical lathe manufacturers, so the specific answer they give is:

From a professional point of view, horizontal lathes are more suitable for processing smaller workpieces. Although vertical lathes are also lathes, this type of lathe is suitable for processing some rotary heavy workpieces, as well as turning of outer circles, holes and end faces.

2. Can vertical lathes be threaded?

Vertical lathes can be threaded, so the answer is yes. Moreover, this is possible for most lathes, not just vertical lathes. However, it should be noted that toy lathes and some special lathes cannot be used.

3. Why is the vertical lathe uneven on the plane?

The vertical lathe manufacturer believes that the vertical lathe uneven plane is mainly caused by: the lathe feed spindle is not perpendicular to the worktable, the feed spindle mechanism is not locked, and the tool wear and excessive material hardness in the vertical lathe can all lead to the above problems. In addition, it is also possible that the workpiece is loose during clamping, which leads to the above problems.

4. Can the vertical lathe turn an arc?

According to the analysis of the vertical lathe manufacturer, the conclusion is that it can turn an arc, so the answer to this question is yes. In terms of specific operation, the workpiece is driven to rotate by the turntable, and the tool moves in a low-speed circular motion along the center point of the circle. After that, the end face of the workpiece is ground by the tool tip to complete the arc turning operation.